|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#231
|
||||
|
||||
Quote:
I think that my float is a bit too high, as the fuel goes right up to the bowl joint at the front. I'll drop it a mm or so, set the slide at a touch above closed, and go from there. I think my metering rod is already at 50.XXmm, so it's pretty close. I just need to confirm the power jet setting (which only affects WOT, right?). It was getting fuel, just not at the right mix.
__________________
Phil (New bike pending...) |
#232
|
||||
|
||||
If/when I get some free time I will definitely let you know. Probably end of February or so before I get up there. Let me know if you are doing the Desert 100 this year, I hope to have a big pit/camp spot all set up for fun and food. And beer.
__________________
Phil (New bike pending...) |
#233
|
|||
|
|||
Call Lectron, they have a viton gasket to deal with any bowl leakage.
|
#234
|
||||
|
||||
Thats ok Phil, and I was in no way implying that my settings would equate to your settings. Simply trying to give you something in the ballpark to get the bike to fire. The float level and slide height in particular.
Also, a complete turn (4 adjustments) is only around 1mm in total. It should have you close. As Stu also suggested, double check the MR. 3-1XL seemed to be alright for our bikes. The MS3 which Kelly developed for the 165 Husky seems to fall a bit flat in the lower mid. |
#235
|
|||
|
|||
Yes on the MS3.
On my Gasser 250, it felt a little lean in the mid, certainly down on power. Where it reared its ugly head was in deep sand. I went back to the stocker and it was all dandy. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
APT SmartCarb | gasgasman | Enduro Product Reviews | 1424 | 12-29-2017 05:01 PM |
Lectron Carb | singletracker | Enduro Product Reviews | 145 | 07-27-2013 12:20 AM |
APT SmartCarb | siaknijustin | Enduro Product Announcements | 19 | 10-02-2012 08:12 AM |
brushy ride review, bike review, Add on parts review | Mazikeen | SouthEast United States | 6 | 09-04-2012 05:34 PM |
Lectron | Binni | Enduro Intake/Carburetion - 2 stroke | 16 | 03-29-2011 09:44 PM |