|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Kickstart spring size?
Does anyone know, or can anyone please measure for me,
The length and width of the kick start spring (the spring that stops the lever from swinging out when riding), and the ball bearing please? My top screw went bye bye and the lever fell off, pinging the spring and bearing into another dimension!
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 |
#2
|
|||
|
|||
Cleaned mine out yesterday and replaced the ball bearing as it was rusty.
I used a 5mm ball bearing - slightly undersize but the next size I had was too big. From memory the spring's about 15 mm. Works fine now. |
#3
|
|||
|
|||
Somehow my spring was still in there!
Measured at 10mm long x 6 wide and wire thickness about 1.25. 6mm bb Thanks!
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Yz kickstart | Diggs345 | "Wanted to Buy" & "Want To Trade" | 14 | 12-04-2016 09:22 PM |
Kickstart | Knobbly | United Kingdom | 4 | 03-25-2013 02:13 PM |
Kickstart problem | gasser250sm | Enduro Engine - 2 stroke | 2 | 07-04-2009 03:16 PM |
What size spring does the stock 03' WP 43mm forks have? | reiterrider | Enduro Suspension | 1 | 02-16-2009 03:12 PM |
Kickstart | steve | Enduro Engine - 2 stroke | 6 | 04-08-2008 03:09 PM |