|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Awesome. I'll order a N3CH tomorrow too and I'll try them both to see which one I'll prefer. Thanx.
|
#12
|
||||
|
||||
Listen to Jake. I've used N3CJ and liked it but now I'm sold on NECW/42/175. Bike still needs small airscrew adjustments.
|
#13
|
|||
|
|||
Do u have a part number or model and year bike that the NECW comes from? Thanx.
|
#14
|
||||
|
||||
Check the link I posted. Read it a few times. I can post the part number tomorrow. The only difference between NECW and the NEDW you have ordered is that the clip positions are staggered half a position, with the NECW being a half a clip leaner.
Test with your NEDW first, and if you find that you need that half a clip adjustment to fine tune, then know its available. You need to be methodical in your approach. Start by setting the float height, the slide height, and the air screw. Confirm your model of carb, your slide number, and if it has a notch/window. Use a baseline to test from and then adjust with intention to address particular throttle positions. Many find indexing the throttle housing so you can visually tell how far its open helps. Don't worry so much about the plug, or the spooge. Use the same oil at the same ratio, and a clean air filter and only evaluate changes on an engine that is up to temp. |
#15
|
|||
|
|||
Quote:
|
#16
|
|||
|
|||
I just tried the N3CH in clip #4. Oddly, it seems very similar to my red JD needle . A little burble just past 1/8 throttle. Running 40pj and 180 main.
|
#17
|
|||
|
|||
Should I dare to try the N1Jk with a bigger pilot? Maybe 45pj?
|
#18
|
|||
|
|||
Go to clip 3
Sent from my iPad using Tapatalk |
#19
|
|||
|
|||
I'll give clip 3 a try and I'll also open up the AS a bit. I'll report back tomorrow with the results. I'll have quite the collection of needles once they all come in. N3CH, N3EG, NEDW, NEDK, red JD. I'm still tempted to give the N1JK a try with a bigger pilot. It honestly gave promising power results in the middle and on top. Seriously, 6th gear wheelies with little effort. Mega power.
|
#20
|
||||
|
||||
Wow, didn't know that was possible.
__________________
2005 GasGas EC300 2017 Beta 300RR Race Edition 2021 TM Racing 300EN Fi (2T) |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
jet needles | gassergrant | Enduro Intake/Carburetion - 2 stroke | 7 | 09-22-2014 12:55 PM |
Where do you get your needles and jets? | motogroove | Enduro Intake/Carburetion - 2 stroke | 4 | 07-21-2011 08:33 PM |
needles? | clerky clerk | Enduro Engine - 2 stroke | 23 | 10-13-2008 04:06 PM |
needles | moff747 | Enduro Intake/Carburetion - 2 stroke | 4 | 07-09-2008 04:43 PM |
Needles | skid jackson | Enduro Intake/Carburetion - 2 stroke | 5 | 08-17-2007 06:25 PM |