|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Anyone make aftermarket jugs?
I am in need of a ec300 jug - 2011 era, anyone make an aftermarket unit or am I SOL?
Thanks, Andrew. |
#2
|
||||
|
||||
I was pretty sure that S3 made a complete cylinder/ head kit?
The piston is marked S3, but the cylinder may be OEM, depending where you are, you can subtract the VAT (tax): http://www.motocrosscenter.com/ecomm...ducts_id=13165 |
#3
|
|||
|
|||
Are you sure its junk? They can be re-plated, exhaust bridges repaired. Post a pick of how bad it is. I use Powerseal USA http://www.powersealusa.com/
I know the owner very well and the quality of his work can not be beat. |
#4
|
|||
|
|||
He is correct, S3 does make a cylinder/piston kit.
__________________
2011 EC300 2013 TXT300 Factory Replica 2014 Polaris Assault 2004 Snowhawk 600H.O. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Would this make your wife/GF mad? | wheelie | General Discussions & Announcements | 14 | 07-13-2012 07:24 PM |
How to make gaskets | Rabbitist | Enduro Engine - 2 stroke | 5 | 09-17-2011 07:46 PM |
fuel jugs | boostedte37 | General Discussions & Announcements | 4 | 01-24-2010 09:55 AM |
Do they make FMF SST | gasser250sm | Enduro Engine - 2 stroke | 1 | 12-26-2008 10:16 AM |
If we make it... would you buy it? | Steve@Motowest | GasGas Member Polls | 12 | 07-09-2008 01:15 AM |