|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Bike bogging at wide open throttle
Evening folks, I?m looking for a bit of advice.
Went out for the day on my bike today and it?s bogging at full throttle. Pulls fine through the midrange and right up until the point where it bogs, which is very nearly the throttle wide open and is quite violent, like hitting a switch. I recently had the carb apart and adjusted the float height as it was leaking fuel out of the overflow and I?m wandering if I may of over adjusted it. I will have it back apart over the coming few days to see what?s up but in the meantime, what else may cause the bike to do this? |
#2
|
|||
|
|||
Quote:
I usually leave my inline fuel filter attached to help keep debris out when I pull the carb for re-jet or service. |
#3
|
|||
|
|||
Could be as you said. I know I have over adjusted mine in the past and it had the same symptom you describe. I ended up using the process that someone on here recommended and used the clear hose running out the bottom of the float bowl to get mine at the right level. I'll see if I can find the link and I'll post it
Josh.. |
#4
|
|||
|
|||
Well, managed to fix my bike this evening.
Quite unbelievably, I removed the float bowl and found the main jet had actually come undone and was rattling around in the bottom of the float bowl. |
#5
|
||||
|
||||
I have heard that will make it run a little rich.
|
#6
|
|||
|
|||
It appears as if you did indeed have some debris in your float bowl... Glad you got it sorted.
|
#7
|
|||
|
|||
Haha I should say so mate
|
#8
|
||||
|
||||
Loose main jets (but not yet bowl debris) will make the bike act very strange too.
|
#9
|
|||
|
|||
That does give you a good indication of where the main jet really comes in! We all know the main affects top end but it's really fun to see how much like a light switch it is. I had a similar experience on a snowmobile once.
|
#10
|
||||
|
||||
I'm glad to hear it was an easy fix!
Thanks for sharing it with us. All the best, Dave. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
94 CR 250 Ground Up Restoration IMS Wide Ratio Transmission Issue | Moto7man | All Other Bikes... | 146 | 01-28-2018 05:57 PM |
open end aluminum throttle tube? | 95jersey | Enduro Chassis & Body | 2 | 01-11-2017 12:34 PM |
Bogging and top end | Capz85 | Enduro Intake/Carburetion - 2 stroke | 14 | 04-05-2015 10:56 AM |
Hanging Idle after wide open | GasGas | Enduro Intake/Carburetion - 2 stroke | 10 | 09-06-2013 04:13 PM |
03 GasGas 450FSE Bogging down, TPS value? | ktownrider | Enduro Engine 4 stroke (including EFI & Exhaust) | 2 | 12-12-2007 10:34 PM |