|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#81
|
|||
|
|||
The 19's have a ground wire from the neg (-) battery terminal to the starter motor mount. This and upgrading the stock battery leads to 8 gauge wire fixed my issues.... So far...
|
#82
|
||||
|
||||
I don't think it's a wiring issue though... There are quite a few 18's getting around without starting issues.. then others that do the funny crank but don't fire trick..
I saw on FB a few pics where someone had some very average electrical joins.. It could be that as well. |
#83
|
|||
|
|||
Quote:
By battery voltage is 13.05 with the bike off. When it?s idling it?s about 13.35 I shut it off and instantly starting dropping. When it fell to 13.20 I tried starting and starter would not spin with the first press of the button, pressed it again and it spun but did not start. What is everyone else?s battery voltage l? |
#84
|
|||
|
|||
I have a volt gauge fitted with a push button so I can check voltage at any time. My new battery will start the bike fine with 12.5v. That?s the lowest it?s been so far. Bike charges to 13.5v while riding and battery drops to 13v when sitting a while.
My previous battery started the bike fine at and over 14v and under that was a sluggish cranking at best. I also had a problem with the start button not being reliable so I have replaced the switch block with a generic one and use the horn button as as the starter Hope this helps Wuz |
#85
|
|||
|
|||
Is there any way to look up a cdi by serial number to see if it has been reflashed? Before I went to buy the bike the dealer told me it was done. When I got there it only had one dot on the bottom so it wasnt done. He said he would get a new one mailed to me so I left with the bike. The new one he mailed has the two dots but now I?m wondering if he just drilled the second one in himself. Running out of ideas as to why the bike won?t fire. All of the electrical connections look good.
|
#86
|
||||
|
||||
Quote:
__________________
2018 EC 300 |
#87
|
|||
|
|||
Quote:
Anybody know if a starter that works can be retro fitted to these bikes? |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2018 Starter Fix Thread - Continued. | webmaster | Enduro Electrical & Wiring | 162 | 04-26-2023 02:57 AM |
2018 | Stoby | General Discussions & Announcements | 23 | 04-18-2018 04:07 PM |
2018 Batteries and Starter Doesnt work! | markwoodlief | Enduro Electrical & Wiring | 81 | 11-30-2017 03:50 PM |
2018 Starter Delete | nhgas | Enduro Electrical & Wiring | 1 | 11-10-2017 07:58 PM |