|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Gasgas ec 300 2015 not reving
hi guys, i have a friend that have a gasgas ec 300, and after last ride his bike started to have some trouble reving, it will not pass the middle rpm's to the higher.
Seems to me that the bike is running to rich, i have a 2018 300 and we swaped some components from my bike to theirs just to see where the problem is: - ignition coil - reeds - carburator - central control unit - spark plug If i open the throtle, or try to rise the front wheel it start's to boggle, but if i give throtle gently it will rev to the higher rpm's. Nothing seems to make a diference on the bike, it have new piston and rings but this problem happen before the new piston. where can i look more? The stator? |
#2
|
||||
|
||||
Have you inspected the exhaust power valve & linkage to make sure it's opening up with the revs?
__________________
Noah 2000 EC250 with 2011 transformation kit, KYB SSS forks, MN street title 16' Ski-Doo XS Renegade X 1200 4T 16' Specialized Fatboy trail 02' ZRX 1200r R.I.P. 72' Olds 500ci, Batten Heads, Street/Drag car, former CarCraft magazine centerfold (has-been) 15' TW200 |
#3
|
|||
|
|||
We got to the origin of the problem, the pick-up sensor support was broken.
we will try to JB weld it and see if it solves the issue. thanks. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2015 GasGas XC250E | Cycleking | Used Bikes | 3 | 10-19-2016 04:55 AM |
2015 GasGas | noobi | General Discussions & Announcements | 86 | 03-20-2016 09:22 PM |
Bike not reving out | eviljim | Enduro Engine - 2 stroke | 2 | 11-18-2014 12:37 PM |
2015 gasgas 450 | bkwdc | General Discussions & Announcements | 7 | 11-12-2014 02:09 AM |
2003 EC300 Over Reving | prunty | Enduro Intake/Carburetion - 2 stroke | 24 | 06-15-2012 07:01 PM |