|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Clutch Slave Cylinder Q:
Searching my parts lists, and googling. I can can not find or confirm
the part number for the clutch slave cylinder rebuild kit. What I did find was a kit for the trials TXT and Pampera bikes. "M0105900" I was not able to figure out if this kit will fit a 1998 EC250. If no one here knows for sure. I will start calling the GG parts suppliers. Thanks, Jeff |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Needed - 2013 EC 300 Clutch Slave Cylinder | TheTrojan | Parts | 3 | 02-20-2020 03:47 PM |
Is it possible to convert clutch slave cylinder to dot4? | jan_b | Enduro Engine - 2 stroke | 7 | 12-19-2014 12:01 PM |
Will a KTM clutch hose fit the banjo bolt on my GG slave cylinder? | bondo | Enduro Chassis & Body | 7 | 12-11-2014 12:53 PM |
clutch slave cylinder hydraulic seal | Boodog | Enduro Engine - 2 stroke | 3 | 07-08-2013 05:45 PM |
Clutch Slave Cylinder Rebuild | newgaser | Enduro Engine - 2 stroke | 5 | 03-17-2012 08:30 AM |