|
Enduro Electrical & Wiring Lighting, Ignition, Wiring, Plugs, etc. |
|
Thread Tools | Display Modes |
#111
|
||||
|
||||
Here is a series of videos that tell you everything you ever wanted to know about the GG starter and how to fix it. This guy did an amazing job and these videos should be in a sticky.
If this info is already here forgive me, I missed it. http://www.youtube.com/watch?v=gk-cu42OJQk
__________________
2011 EC300 |
#112
|
|||
|
|||
hi, I have the same problem on my gasgas ec 2015 the bendix wheel, all the gears are a place but not to cross over the gear wheel.
I also tried with the battery of the car but it does not work. some time ago I changed the gear with a piaggio scooter but I did not read about extending the spring. therefore if enlarged the spring that holds the weights could work. greetings from Italy |
#113
|
|||
|
|||
Finally!
Finally found this thread! LOL I watched anesthesiadreamin's eight-part youtube video on the subject, but I couldn't remember the GGrider's member he named that he got all the info from.
Subscribing now before I even read it, so I don't lose it. Here is number eight in that video series: GasGas Starter FIX part 8 FINAL: https://www.youtube.com/watch?v=6rwq9RemuQI |
#114
|
|||
|
|||
Found this too late, sold my GasGas. I had tried all kinds of mods. After first broken set of Bendix and flywheel gear, i got the spacing right on the secound very expensive set.
But the Starter in best case (clean and relubed with very little thin oil) always only worked as a Re-Starter for warm engine. I am a bit dissapointed that GasGas over the years never refined the springforce in the Bendix and a customer must come and find working Honda parts. I think that the spring was strengthened because the Bendix works vertical and every bump might push down the gear. Did anyone observe an engaging noise when landing from a jump or see a respective wear on the parts? Great forum! Regards, Erhard |
#115
|
|||
|
|||
I finally decided to sort the starter on my 2011. Below is part six video of the previously posted thread. My ring gear was in great shape and my GG bendix was in good shape too, not rounded or chewed up at all, it just would not engage.I bought the listed CH 80 starter on Amazon and last night I followed the video directions and IT WORKS PERFECT!
https://youtu.be/VxGcd1eqdd8
__________________
2011 GG EC 300E, 1994 CR 250R, 1984 RM 250 E, 2022 Ranger 300 "If you stop eating donuts you will live 3 years longer. It's just 3 more years that you want a donut." ―Comedian Lewis Black "I think best when I have a wrench in my hands." Soichiro Honda "Dreams are messages from the deep." -Unknown Sardaukar |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Anybody have an 02/03 450 FSE that actually works ? | wakeymatt | General Discussions & Announcements | 5 | 08-09-2012 06:07 AM |
Does anyone know how the compression release works? | stay_upright | Enduro Engine - 2 stroke | 1 | 07-24-2009 10:37 AM |
04 300 fork kit - Pivot Works | bocoz702 | Enduro Suspension | 2 | 02-12-2007 08:24 AM |
300xc what gearing works best?? | Dingoe | Enduro Chassis & Body | 6 | 02-05-2007 03:47 PM |