![]() |
|
General Discussions & Announcements General Announcements, General Questions, e.g. What bike do I buy?, etc. |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hi, My power valve assembly on my GasGas Ec 125 2006 is all right. Ive went over the manual multiple times and it is as it should.
When I attach the governer arm or what its called to the arm that actually raises the power valves, it gets stuck when I go to tighten it. If I tighten it a very tiny bit, it is hard to raise the valves. If I tighten it to a torque that feels legit to me so it doesnt vibrate loose, the power valve doesnt move at all. Im not able to raise the arm. Why is this, im confused? I popped of the cover when the gasser was on and when I give gas, it doesnt budge. This was in neutral gear however. Im not sure if they open in neutral but I suppose they do? Or is it different when ur actually in gear? Thanks a lot guys |
#2
|
||||
|
||||
![]()
In gear or not won't make any difference.
On the bigger bikes there is a bent piece of wire that moves vertical to raise the lever. It has a stepped bolt on the triangular plate that the valve attaches to. Is it the same arrangement? They use a nylock nut you have to burn plastic out or it can break this bolt then use a new one, available at hardware store.
__________________
'07 EC300 GG '14 TXT250 GG '? 496 CPI Cheetah RZ/RGV hybrid '22 765 Street Triple RS '21 XTrainer '69 Stinger T125 Suzuki '23 TRS 250RR (it's a Trials thing) |
#3
|
||||
|
||||
![]()
Get a new nylock nut and put it on but do not tighten it up against the actuator arm the nut will not move.
__________________
02 EC 200 03 MC 250 88 VT 800 01 TXT 280 |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Old EC250 idle issue and power valve leaking... | 2ndGen | Enduro Intake/Carburetion - 2 stroke | 4 | 09-08-2021 09:49 PM |
Power Valve Adjustment issue | Dougie Dangerous | Enduro Engine - 2 stroke | 12 | 06-10-2020 02:26 PM |
2018 ec 300 power valve issue | Sterlo300 | Enduro Engine - 2 stroke | 8 | 10-27-2018 08:46 AM |
Ec300 rattle/power valve issue | Smithwoodwest | Enduro Engine - 2 stroke | 6 | 12-22-2016 07:46 PM |
ec125 -01 power valve issue? | Nicolas89 | Enduro Engine - 2 stroke | 83 | 08-06-2014 04:33 AM |