#21
|
||||
|
||||
Quote:
By the way, I appreciate it when the importer takes the impetus to find aftermarket part sources for a brand that fill a void that the aftermarket mfgs would not go after. |
#22
|
||||
|
||||
Ive dealt with Jeff Roberto at east coast wheel, they built a 18 incher for my mc-250 using a ktm exel hoop. I was very happy with their services.
|
#23
|
|||
|
|||
Quote:
I followed the instructions on setting sag on the sight (shock spring 10mm compressed) for my 2008 EC and ended up with the forks 2/8" up and 110mm race sag and 30mm static sag and really rails in the corners, never pushes. I have bars on the front triple clamp's holes. BTW I'm 5 11 and weigh 190 lbs. My clickers are set at : Forks: Compression 17 out Rebound 6 out Shock: LS compression 19 out HS 1 1/2 out RB 20 What clicker settings does the "R" have?
__________________
EC250 2008 Skid plate, rad braces, Fork bleeders Drz 400 Motard '03 (full spec) Yz 250 '06, KTM exc 250 '05, exc 250 '04, exc 250 '02 WRF250 '02, KDX 220 '98, DT200R '93 all sold |
#24
|
|||
|
|||
GG27, similar numbers here as well for sag.
Same weight but a little shorter so I'm on the back TT holes. I have my forks up 3/8" but I might move them down a bit. I have my clickers almost all the way backed out (Arizona rocks). |
#25
|
||||
|
||||
Awesome mate,
Just bought my ec300 and was wondering what to set mine at for a starting point. I am basically same height and weight and had already set everything close to what you have but think I will raise the forks through a little. Cheers |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
F_G's son makes GoFasters.com "Race News" | AZRickD | Ride Reports | 4 | 05-28-2009 09:46 PM |
'06 EC300 Rear wheel "top-hat" bushing | Eugene | Enduro Chassis & Body | 1 | 01-23-2009 10:27 AM |
2008 "Racing" model | gasgasman | General Discussions & Announcements | 16 | 09-21-2007 11:40 PM |
Recommendation: add "Injury/Recover" and "Riding Techniques" sections | MattR | Suggestion Box | 2 | 07-18-2006 09:19 PM |