2010 250 EC Jetting.

[swazi_matt]

Originally Posted by chucky

Hey Swazi

My wife has a 200 . I am running the N3EH needle , it is a midrange to top needle , however I have set it up for the most linear and smooth power .

My settings are: 170 main
42 pilot
airsrew 1.75 out
Needle N3EH 4th clip ( no bog off idle)
Altitude ( JHB) 1600m

I know that Wayne Farmer runs his 2010 300 with the same needle at clip 2 and 170 main and I think a 40 pilot , however that is for the offroad nationals , I would run slightly richer for more bottom end .
I have ordered a JD jet kit as I believe the N3EH is not so good for the bottom end torque.

Just my 2 cents .

let us know how it goes, I have more bottom end than i am used to so am happy at teh moment. Being in jozi you could also go to freez (on the other forum!) and get him to dyno the jetting in. I know that he has complained about the jd kits not running as well as set by jd

[Rod Overstreet]

On my '10 300, I played around some with a 38 pilot and 172 main, but ended up going back to stock 40 pilot and 175 main. Needle in the 2nd notch from the top and air screw at 1&1/2 turns out. The bike pulls smoother off bottom and the plug color is a dark chocolate brown.

[swazi_matt]

Originally Posted by swazi_matt

let us know how it goes, I have more bottom end than i am used to so am happy at teh moment. Being in jozi you could also go to freez (on the other forum!) and get him to dyno the jetting in. I know that he has complained about the jd kits not running as well as set by jd

@ Chucky have you tried out the JD kit yet? how about a review?

[Viet Nambotin]

I will have my 2011 EC250 pretty soon


I am assuming my PWK jet assortment will be the same

this is a different version than a air striker yes??

thanks in advance