|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Intake/Carb FAQ
FAQ = Frequently Asked Questions...
I am looking to add a "frequently asked questions" section to the website to save space and time.... I will have it partitioned into categories that correspond to the categories in the forum here - engine, electrical, chassis, etc. What do you think should be in the intake/carb FAQ? thanks, jeff Last edited by webmaster; 08-02-2006 at 02:46 AM. |
#2
|
|||
|
|||
Jeff,
Addressing questions about jetting would be good. However, there are different perspectives, which can become controversial. I suggest setting up a tabular listing for people to share the jetting they have found to work well along with the specific conditions (temp, elevation, riding type). This could enhance the spirit of sharing.
__________________
Eric K '06 GasGas EC300 '01 GasGas XC300 |
#3
|
|||
|
|||
Questions:
Can I change jets without removing the carb? What happens to my jetting if I put such-and-such reeds in my Rad valve? How do I properly vent the carb? How can I tell if my reeds are bad? I foul a lot of plugs. Is it my jetting? How about a link to an online air density calculator? |
#4
|
||||
|
||||
I have had a bit of frustration finding a jetting guide. I have found formulas and great pictures on other sites. We could adapt it to this site. Even if we could make a chart that could get us close. I know it is easy to change the jets out but it takes for ever, especaly when you change altitudes as much as I am. Just a though!
MikeB PS. Good luck with the site Jeff! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
300 ec Intake rubber | Luke12379 | Enduro Intake/Carburetion - 2 stroke | 0 | 03-27-2010 09:34 PM |
RB carb | 101racing | Enduro Intake/Carburetion - 2 stroke | 15 | 05-22-2009 10:33 AM |
What carb do I have? | forgiven | Enduro Intake/Carburetion - 2 stroke | 1 | 05-04-2009 09:51 PM |
RB Carb Mod | RBD | Enduro Product Announcements | 10 | 06-29-2008 07:57 PM |