|
Enduro Chassis & Body Enduro Frame, Plastic, Brakes, Bars, Controls, wheels, tires, sprockets & gearing. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Will any year CR250 pegs fit on the 2011 gassers?
I was looking at these red anodized pegs..........
http://www.motosport.com/dirtbike/pr...NDA;CR250;2006 |
#2
|
|||
|
|||
I thought it was 98-current YZ's that crossed over.
__________________
2011 EC300 2013 TXT300 Factory Replica 2014 Polaris Assault 2004 Snowhawk 600H.O. |
#3
|
|||
|
|||
I just purchased a set of pro taper YZ foot pegs and they do fit my 2011 300, however:
1) The right side pegs needs serious grinding to allow even partial folding due to interference with the rear brake lever. Gas Gas pegs are cut asymmetrically to allow folding clearance. 2) The pivot of the YZ foot peg is mounted further aft than Gas Gas pegs. This moves the base of the foot peg further forward and reduces the amount of room between the tip of the gear shift lever and the foot peg. I could barely get my foot under the shift lever with the YZ pegs installed, so I re-installed the stock pegs for now. If someone offers an extended shift lever I might consider re-installing the YZ pegs. Steve |
#4
|
|||
|
|||
Quote:
|
#5
|
|||
|
|||
The 95-98 cr pegs work for sure,, I think most of the cr 2-stroke pegs are the same, and yes they are the same as most of the yz pegs. The early GG used the Honda pegs in production. The serial # on the bottom of the peg is the same as the Honda production peg on a 98 cr250. Honda outsourced it's smaller parts as does most of the manufacturers. Not a surprise when some cross paths.
__________________
Steve 16 Beta 350rr 04 KTM 525 sx/exc gone 03 KTM 625 sxc-rehab unit-did its job and now gone 03 GG 250 ec-gone 97 GG 250 ec Gone |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Year By Year Comparison for 300 ?? | GasGasDreamer | General Discussions & Announcements | 21 | 05-31-2011 10:53 PM |
2011 Model Gassers | JRDoz | General Discussions & Announcements | 85 | 09-25-2010 04:55 PM |
CR250 Rod kit on EC250? | twistywizard | Enduro Engine - 2 stroke | 3 | 01-20-2010 03:45 PM |
Gassers in NC | dmstarr | General Discussions & Announcements | 4 | 11-21-2007 11:44 AM |