|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Jetting Question.
I have a '05 250 DE. I have a trip coming up and will not have much of a chance to ride the bike prior. The bike currently has:
180 Main 40 Pilot NIEF Needle #2 down from the top #7 slide I run pump fuel with Klotz R50 @ 40:1, and live in Indiana which is about 600 feet above sea level. My question is will this jetting be relatively close for my conditions. |
#2
|
||||
|
||||
Where are you going? Same elevation? Does it run good now? I don't run the N1E series needles, prefering the LTR single taper needles since my '00. Sounds close though, maybe a size rich on the main for that needle.
If you go with the LTR try: 182 main 45-48 pilot LTR -0(newest) #3 AS 1.75 out #7 slide I'm at similar elevation and mine rips. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Jetting question | lech | Enduro Intake/Carburetion - 2 stroke | 3 | 03-07-2008 05:12 PM |
Jetting question. | bens25au | Enduro Intake/Carburetion - 2 stroke | 2 | 02-23-2008 05:57 PM |
Jetting question | Airborne | Enduro Intake/Carburetion - 2 stroke | 1 | 06-12-2007 05:49 AM |
Yet another jetting question... | Brian VT | Enduro Intake/Carburetion - 2 stroke | 11 | 05-22-2007 10:48 PM |
Question: LTR Jetting an MC High comp head | Ryno | Enduro Intake/Carburetion - 2 stroke | 8 | 02-20-2007 02:22 PM |