|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
 |
|
|
Thread Tools | Display Modes |
|
|
|
#1
06-26-2011, 09:01 PM
|
|||
|
|||
The nozzle jet shroud has a fairly large notch in it. There has been some discussion about the value of the notch.
It feels like I am getting some pull-over from the needle since the slide has to be raised to get an idle. Should the air screw be providing all the air needed for idle if the jetting is correct? The higher the slide the poorer the quality of idle. Does a leaner slide pass more air at idle or does it only reduce the "signature" off idle?
__________________
2011 EC250E 
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Jetting (Another thread) 2011 SD300 | biggstr6 | Enduro Intake/Carburetion - 2 stroke | 0 | 05-23-2011 08:57 AM |
| 2011 125 6 days jetting | orangezuk | Enduro Intake/Carburetion - 2 stroke | 11 | 04-28-2011 11:09 PM |
| 2011 SixDays 250 JD jetting (YZ kit) | thumperrider1 | Enduro Intake/Carburetion - 2 stroke | 3 | 04-24-2011 08:04 PM |
| Jetting for 2011 xc300 | jeffs2200 | Enduro Intake/Carburetion - 2 stroke | 18 | 04-08-2011 04:09 AM |
| 2011 jetting | mikemoto | General Discussions & Announcements | 7 | 01-22-2011 03:16 PM |
Hybrid Mode
