|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Your 300 Power loss solution?
Simply a single symptom and solution. No questions please. This should be a resource for the suffering.
What fixed your bike when power went very flat somewhere in the PB? Here's my final piece, although there where a few that helped. No power past mid-range and the packing was soaked. Worn out float pin tower hole. The float moved sideways from vibration. |
#2
|
||||
|
||||
Muffler internal tube broken causing resrtiction.
JD kit livend it up all way thru. |
#3
|
|||
|
|||
Bump-arino
|
#4
|
|||
|
|||
Two years of packing changes. Thought all was good, then during some rides I noticed a lack of bottom and top. I figured the packing needed changing. It was looking pretty fresh, but I had two inches of old, dense packing blocking the hole into the silencer. A half hour with various implements and it was all clean and ready to rip.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Old gas and power loss? | EcEvan03 | General Discussions & Announcements | 16 | 04-27-2011 06:40 PM |
power loss | glassman581 | Enduro Intake/Carburetion - 2 stroke | 3 | 03-22-2011 11:19 AM |
Loss of a friend | roostafish | Western United States | 19 | 02-23-2011 10:16 PM |
Kickstand solution? | Krieg | General Discussions & Announcements | 12 | 01-22-2011 01:57 AM |
Cycra Probend handguards w/ Solution mount | anathema | Enduro Product Reviews | 8 | 04-21-2008 11:28 AM |