|
Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Great news Bruce. I was just saying that it was sad that you couldn't get that thing running.
|
#12
|
||||
|
||||
great news bruce,but I was kind of hoping for a great deal on an 05 fse450 needing a little TLC
|
#13
|
||||
|
||||
Back when I had a Cannondale, the mysterious "shut off" syndrome could be usually be traced back to the main system relay. Its an electro/mechanical device and affected by vibration. ECUs are very sensitive devices and clean power is a must. I replaced it with a solid state relay (SSR) and had no problems. I also added another to drive the fuel pump rather than use the integrated driver in the ECU (that would fail occasionally). It took a little reengineering but it was worth it in the long run as the bike was bulletproof afterwards. I'm not familiar with the FSE but I would think that there is a similar main relay to switch power to the ECU.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Throttle cable / slide | Gassey fan | Enduro Intake/Carburetion - 2 stroke | 4 | 03-04-2009 11:23 AM |
Throttle Cable | steve | Enduro Intake/Carburetion - 2 stroke | 5 | 02-14-2009 02:39 PM |
throttle cable | steve | Enduro Intake/Carburetion - 2 stroke | 5 | 02-08-2009 06:17 AM |
Throttle cable | dave948 | Enduro Intake/Carburetion - 2 stroke | 7 | 10-10-2008 04:16 PM |
Throttle Cable Crossover | Ed Ventura | General Discussions & Announcements | 8 | 08-29-2008 05:55 AM |