|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2001 xc250 case sealant with no gasket
Getting ready to put my cases back together but dont have gasket. Is yamabond ok? Ive done this with kx250 i built, but it did not have coolant flowing through both halves.
Sent from my DROID RAZR using Tapatalk 2 |
#2
|
||||
|
||||
You will need the gasket.
The gasket is also a "spacer". Not using one will create some clearance issues. |
#3
|
||||
|
||||
+1, I test fitted cases dry with no gasket in my '00 years ago and there was thrust clearance problems with the transmission. Use the gasket, but a light coat of Yamabond, Threebond, Hylomar, etc. on it is not a bad idea. I always use a gasket sealer on paper gaskets to avoid problems. If the new replacement center case gaskets are like other gaskets on the '12 (metalized, with a thin rubber like coating) this will not be neccessary.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2001 xc250 crank nut won't budge | 70455 | Enduro Engine - 2 stroke | 10 | 11-15-2012 11:32 AM |
1997 kx airbox onto 2001 xc250 | 70455 | Enduro Chassis & Body | 3 | 10-15-2012 10:23 PM |
2000 XC250 CDI for a 2001 UK EC300 | krazy | Enduro Electrical & Wiring | 1 | 09-14-2008 04:58 PM |