|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
 |
|
|
Thread Tools | Display Modes |
|
#11
11-25-2012, 01:07 PM
|
||||
|
||||
Those pesky crank stuffer bolts can ruin your day!
__________________
Rick 99 EC 200 06 RM 250 AMA D36 375X OTHG 375S ***Thanks for the support : Twin Air /O'Neil Racing / Race 100% / Matrix Concepts / ODI / Mika Metals 
|
|
#12
11-25-2012, 02:09 PM
|
|||
|
|||
|
Red loctited and torqued all stuffer bolts.
Few wraps with a mallet and now 0.038" feeler gage goes and 0.039" does not. The 0.8 to 1.0 mm limit translated to 0.031 to 0.039". I may use the hf hydraulic press to get nominal. From past experience using the press to set side clearance is sort of like utilizing "Kentucky windage". A 0.005" move is tough when the stick/slide motion requires 15 tons. Sent from my DROID RAZR using Tapatalk 2
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1997 kx airbox onto 2001 xc250 | 70455 | Enduro Chassis & Body | 3 | 10-15-2012 10:23 PM |
| Rod side clearance question | Bailey28 | Enduro Engine - 2 stroke | 15 | 09-25-2011 08:17 PM |
| 2000 XC250 CDI for a 2001 UK EC300 | krazy | Enduro Electrical & Wiring | 1 | 09-14-2008 04:58 PM |
Linear Mode
