|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
Got it all fitted up last night, runs sweet as . No leaks, quite an easy job. What's the norm for running in? 2-3 heat cycles with light use? How much gearbox oil do I want in there, sure someone said less than recomended to stop cluch drag?
|
#12
|
||||
|
||||
Just a quick heads up not sure if you are goin to or have removed the R/H side casing but recently i rebuilt my EC250 and when i got the gasket kit for it the new side casing gasket was a terrible fit i ended up refitting the old one.
Also brake and clutch cleaner is a good product to break down the watery oil in the gear box. (do not run the engine with it) I filled up the box with it left it for a while and then drained. done that a couple of times it cleaned up a treat. |
#13
|
||||
|
||||
Thanks, I'm gonna flush it through a couple of times with ATF.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
water pump? | nhrider | Enduro Engine - 2 stroke | 17 | 12-21-2008 12:05 AM |
water pump seal | skid jackson | Enduro Engine - 2 stroke | 1 | 11-14-2008 11:30 AM |
Water pump seal | brains | Enduro Engine - 2 stroke | 2 | 07-26-2007 10:25 PM |
Water Pump Seal Removal | Tricky Dicky | United Kingdom | 0 | 03-18-2007 09:11 AM |
removal of water pump seal | clangstone | Enduro Engine - 2 stroke | 1 | 10-26-2006 11:29 AM |