|
Enduro Product Announcements Announce new gasgas enduro products here - Vendors Welcome... |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Howdy Rodent. Good to meet you yesterday. Did you manage to find the motivation today? How did they work?
|
#12
|
||||
|
||||
Nah, went for a ride on the road bike with my brother......I did look at it though
|
#13
|
||||
|
||||
I fitted my kit today, the blocks needed to be taken down a whisker as they were too tight in the swing arm(only slightly). The kit comes with an aluminium nut which I personally don't have a great deal of faith in, so I used a steel Yamaha nut mentioned in the thread below.
http://www.gasgasrider.org/forum/sho...86&postcount=8 All in all the kit is well made but by the time it's landed in Australia the price is a bit exy. Last edited by rodent; 02-15-2020 at 01:58 AM. |
#14
|
|||
|
|||
Bugger. I didnt put the locknuts on mine. Did you find instructions somewhere that suggested they need to be fitted?
I imagine that once the axle nut is tightened it should not move much at all (I hope). |
#15
|
||||
|
||||
No instructions, I just rather that the threads weren't getting pounded should there be any movement
|
#16
|
||||
|
||||
Why's your bike so clean rodent?!
__________________
'18 Gasgas XC250 |
#17
|
||||
|
||||
'Cause I don't ride it
It's only got 22 hours on it, but I am a stickler for keeping shit clean......And my shit doesn't get "rode hard and put away wet" I do have a '12 Suzuki Bandit with 27000ks on it that still looks new........if you're interested |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2018 swing arm / axle adjuster | chunkysoup | Enduro Chassis & Body | 5 | 05-21-2018 06:47 AM |
Ken Block...at it Again! | Rick | Pictures & Videos | 5 | 11-06-2009 11:56 AM |
Main Jet Motorcycles Enduro Axle Nut/Wrench/Axle Pull | HydroDog | Enduro Product Reviews | 2 | 09-24-2009 12:12 AM |