|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
You'll find that buying low volume from anywhere bumps the price up by an indecent amount....the place I bought mine from quotes ?3.15 for two and ?10.50 for 100 !!!
As an example, I bought a Bellleville Z25 washer for my Benelli the other day....bl**dy thing cost ?3.95 for a poxy conical washer ! Have sourced a place in France that can ship em for a fraction of the cost - trouble is I need to buy 1000 to get them that cheap and they don't exactly rate as a highly consumable item if you see what I mean....thats the advantage of group or bulk buys, but again, the Benelli is a relatively low volume bike so I can't justify the initial outlay for the washers as I'd never shift em.... If there's enough interest in the O rings I'll consider buying them by the 1000 to get the price right down and shipping requested numbers worldwide at cost plus a bit to cover my expenses.
__________________
Dave H BMW R1150GS Moto Morini 1200 Corsaro BMW R1200S GasGas EC300 |
#12
|
||||
|
||||
Sounds good to me mate,
I am in Australia but I am sure postage would not be that much. I would be keen for a dozen or more. Even a couple of dozen. Cheers Mark |
#13
|
||||
|
||||
Quote:
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
? on exhaust for 2010 EC300 | john01 | General Discussions & Announcements | 29 | 11-16-2010 01:33 AM |
EC300 exhaust note | BULTACOBRIS | Enduro Engine - 2 stroke | 5 | 04-27-2009 04:35 PM |
ring gap specs | jostby | Enduro Engine - 2 stroke | 9 | 10-27-2008 06:18 PM |
Ring Question | PEB | Enduro Engine - 2 stroke | 4 | 02-14-2008 01:10 PM |
Ring gap | brains | Enduro Engine - 2 stroke | 1 | 07-10-2007 06:09 PM |