Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 02-08-2012, 09:20 PM
desertgasser300 desertgasser300 is offline
Banned
 
Join Date: Feb 2011
Location: Hot A@% desert AZ.
Posts: 1,872
Default Part ID??

I'm putting my 97" back together and have found this piece. I do not recognize it and can't find it in the parts microfiche. This was in a box that my mechanic handed me after they had split the cases for me. It is just bigger than a quarter.




Reply With Quote


  #2  
Old 02-08-2012, 09:26 PM
lonetree lonetree is offline
Senior Member
 
Join Date: Feb 2011
Location: Victoria, Australia
Posts: 186
Default

looks like the spacer that goes over the front sproket drive shaft, and SEALS the gearbox....
pull off the front sproket and check beween the seal and driveshaft.
Reply With Quote
  #3  
Old 02-08-2012, 09:45 PM
desertgasser300 desertgasser300 is offline
Banned
 
Join Date: Feb 2011
Location: Hot A@% desert AZ.
Posts: 1,872
Default

Ah, you are correct. Thank you. Are there o-rings that go on the inside of this?
Reply With Quote
  #4  
Old 02-08-2012, 10:09 PM
GMP's Avatar
GMP GMP is offline
Senior Member
 
Join Date: Jul 2006
Location: Jefferson Twp., NJ
Posts: 7,597
Default

Yes there are.
Reply With Quote
  #5  
Old 02-08-2012, 10:49 PM
lonetree lonetree is offline
Senior Member
 
Join Date: Feb 2011
Location: Victoria, Australia
Posts: 186
Default

yep, mine had 2 o rings, one in the groove in the spacer, the other just behind it on the shaft. not sure if thats how its supposed to be, but everything lines up perfectly on mine....
Reply With Quote
  #6  
Old 02-09-2012, 09:04 AM
GMP's Avatar
GMP GMP is offline
Senior Member
 
Join Date: Jul 2006
Location: Jefferson Twp., NJ
Posts: 7,597
Default

Thats correct. Without the proper fit and seal between the collar and shaft, oil will leak out (and worse, water in) between the collar and shaft.
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Fse Part , What is it , and where is it from ??? Gerko Enduro Engine 4 stroke (including EFI & Exhaust) 7 02-06-2011 07:12 PM
To part it or not? PEB General Discussions & Announcements 2 10-02-2008 05:03 PM




All times are GMT -5. The time now is 06:53 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org