|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Best Carb Size 2003 EC125
If you were to choose a carb for a stock 2003 EC125, what carb flavor and size would you choose? I purchased one of these bikes without a carb and I need to get one for it. I was thinking maybe a Keihin 35mm or 36mm PWK would be a good choice.
|
#2
|
|||
|
|||
38 is stock and mine runs pretty good with it. Maybe I would go for a 36 but not smaller.
__________________
4 strokes are only good for power generators |
#3
|
||||
|
||||
36 if you want a little more bottom and mid power. 38 if you want it to scream on top.
__________________
15 GASGAS EC 250 19 Sherco SE 125R |
#4
|
|||
|
|||
Bottem and mid power on a 125?!??
I would go for the 38 because there the jetting is known By the way: Main jet 185-195 Pilot jet 45-50 Needle NOZI 2. Clip Slide 7 Air screw 2-2.5 out
__________________
4 strokes are only good for power generators |
#5
|
||||
|
||||
Quote:
The gassers are a PIA to jet. This 125 talk has me out in the garage spliting the cases to get my husky going again.
__________________
15 GASGAS EC 250 19 Sherco SE 125R |
#6
|
||||
|
||||
Thank you for the input on the 38s. Has anyone run a 36?
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Carb size on US Spec 2013 XC300? | FastFast | Enduro Intake/Carburetion - 2 stroke | 4 | 04-24-2014 03:19 AM |
2011 Carb Size 36 or 38 | BrentMartell | Enduro Intake/Carburetion - 2 stroke | 15 | 05-23-2011 09:25 PM |
'09 Ec125 | Nhuskys | General Discussions & Announcements | 8 | 11-10-2008 07:07 AM |
Carb Vent Tube Diameter/Size? | Captccb | General Discussions & Announcements | 1 | 11-05-2007 02:36 PM |