Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Engine - 2 stroke

Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc.


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 06-17-2018, 06:15 PM
Cball917 Cball917 is offline
Member
 
Join Date: Nov 2017
Posts: 30
Default 2002 xc125 trouble

Hey guys I haven?t been on in a while being wide open coaching ball. I am hoping you guys can help me out. Last weekend we went on a pretty good ride. Bike ran great until we were almost back to truck. Kinda choked out and went to crank and had very little compression. Figured I may have broke a ring so I pushed it back to trailer. Tore into it this weekend and found the left side power valve broken and it did break a ring. That brings me to this..... the cheapest place I can find a valve is $110. The cylinder wall looks fine and mics out to about 53.85mm so I don?t think it?s ever been touched. The piston looks very good except for one tiny place in the top edge. So I have a few questions.
1. You guys have any better advice on fixing the valve. Cheaper??
2. You guys think I need to change piston. ?
3. Last big question is when I left it last night with head off apparently the coolant hose slipped down from where I had it pinched off and filled the crank and rod cavity full of coolant. How do I drain this? Please don?t tell me I have to split the case
Any help or info will be greatly appreciated
Reply With Quote
 



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
2002 XC125 to 2011 Conversion lklive Enduro Chassis & Body 1 04-17-2013 07:43 AM
Rad Guards 2002 xc125 lklive Enduro Chassis & Body 0 04-12-2013 04:18 PM
Clutch Trouble sammyj18 Enduro Engine - 2 stroke 10 07-24-2009 10:39 PM
Is it just me? Rimlocks - any trouble? 3hunerd Enduro Chassis & Body 13 04-18-2008 07:14 PM
Is Gas Gas in trouble in the U.S. GregM General Discussions & Announcements 14 12-29-2006 08:55 AM




All times are GMT -5. The time now is 11:54 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org