|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Clutch hub nut GASGAS ME25632028,Honda 90235-ka4-000
FYI GASGAS #ME25632028 clutch hub nut is 18mm x 1.0 thread pitch.A Honda nut #90235-ka4-000 will fit.The only difference is 30mm socket to remove GASGAS.27mm for the Honda.Nut is from alot of cr250's and 125's.If your in a pinch,these are easier and cheaper to get...
|
#2
|
|||
|
|||
Bringing back the dead, but also showing my appreciation!!
__________________
2006 EC300 Enduro - Ignitech CDI - 38/NECW#2/165 FMF gnarly, FMF shorty, .50 front 5.7 rear 2016 RM-Z450 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Honda XR's | roostafish | All Other Bikes... | 8 | 04-13-2011 04:07 PM |
Has anyone tried to put forks from a honda on a Gas Gas | mikemoto | General Discussions & Announcements | 9 | 12-20-2010 07:54 AM |
Honda Clutch | on2wheels4ever | Enduro Engine - 2 stroke | 1 | 09-01-2010 06:55 PM |
honda 84 canister | peterr | All Other Bikes... | 1 | 02-27-2007 02:49 AM |