|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#191
|
||||
|
||||
Quote:
how do you go "half a clip"?
__________________
Thanks to FLY Racing. |
#192
|
|||
|
|||
You can get tiny .5mm washers from the local hobby shop... For example, if you want clip 2.5 instead of 2, stack a .5mm washer under the E clip and it will raise it the 1/2 clip distance. A full clip is 0.9mm from one to the next.
I know .5 and .5 is 1.0, but this .5 is close enough.
__________________
'10 EC300 -- very happy |
#193
|
||||
|
||||
Quote:
__________________
Thanks to FLY Racing. |
#194
|
||||
|
||||
or.. the more permanent and correct way is to buy the needle that is half a clip leaner :P
In this instance, i am using N3CH on #2. Half a clip leaner is N3EH on #1. |
#195
|
||||
|
||||
I think I am all done tuning........
I think I have found the set-up I am happy with:
2010 300 4000-7000' 50-80' F 38, N3CH #2, 175 Tried this set up for the first time earlier in the week, works just fine. I think I could go just a little leaner on the clip, but it is close enough fore me J
__________________
2015 KTM 450 XCW 2014 350 XCF Wife's 2009 200 ec. Loving it 2007 Beta Rev 3 270 2007 KTM 200 XC Wife's Public Lands belong to the Public |
#196
|
||||
|
||||
Quote:
If you could get your hands on a N3EH and try pos one it might be just what the needle is asking for. |
#197
|
||||
|
||||
hmm
Quote:
By mistake I purchased a N3EG thinking it was a N3EH....... I dont think I will monkey with it..........but I change my mind often so you never know. Thanks to the folks on this site/thread that helped me get to these settings as I am new to the GG world
__________________
2015 KTM 450 XCW 2014 350 XCF Wife's 2009 200 ec. Loving it 2007 Beta Rev 3 270 2007 KTM 200 XC Wife's Public Lands belong to the Public |
#198
|
|||
|
|||
Needle profile comparison
For Jakobi:
N3CH vs. N3EH. Very little difference here.
__________________
'10 EC300 -- very happy |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2010 250 EC Jetting. | enduro1 | Enduro Intake/Carburetion - 2 stroke | 13 | 08-19-2010 05:56 PM |
2010 Sachs fork factory compression stack specs(ec300) | bergerhag | Enduro Suspension | 9 | 07-01-2010 11:18 PM |
2010 EC250 Jetting | WTEC | Enduro Intake/Carburetion - 2 stroke | 1 | 03-26-2010 09:41 AM |
jetting for new 300 racing 2010 | fabulous furry | Enduro Intake/Carburetion - 2 stroke | 9 | 08-11-2009 09:28 AM |
04 EC300 jetting? | DWreck | Enduro Intake/Carburetion - 2 stroke | 13 | 11-26-2006 08:12 PM |