|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Gearbox oil 10 40?
I'm going to replace my gearbox oil this weekend, I have some castrol R1 10 40 left over from my 4 strokes, is this a bit to thick to use? If not I will go and pick some mtx up
|
#2
|
||||
|
||||
10-40 is no problem
|
#3
|
||||
|
||||
This is what I use its very good
|
#4
|
|||
|
|||
I changed the oil, clutch still squeals a bit it you take off from a standing start but not as bad as before
|
#5
|
||||
|
||||
If the oil was very dirty I would change again just to make sure all is flushed out
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ec300 gearbox | stuart | Enduro Engine - 2 stroke | 1 | 03-14-2015 02:50 PM |
Gearbox oil | eviljim | Enduro Engine - 2 stroke | 37 | 06-07-2014 01:34 AM |
gearbox question | mikevancapel | Enduro Engine - 2 stroke | 2 | 01-01-2012 09:57 PM |
ec 400 gearbox issue | Paul Somerville | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 09-05-2009 10:17 AM |
Milky gearbox oil | juzzasmith | Enduro Engine - 2 stroke | 10 | 03-12-2007 05:40 PM |