Rieju & GasGas Legacy Riders Club Forum  

Go Back   Rieju & GasGas Legacy Riders Club Forum > GasGas Enduro Technical Forums > Enduro Intake/Carburetion - 2 stroke

Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc.


Reply
 
Thread Tools Display Modes
  #1  
Old 10-05-2018, 07:58 PM
Wypipo Wypipo is offline
Senior Member
 
Join Date: Sep 2018
Posts: 131
Default Super fast idle after removing cable choke

I took the needle, main and pilot out to see what was in there. Put it all back in. Removed the cable choke and put in a plunger choke from a 2018 YZ250. 38mm Keihin PWK just like the GG. Any idea where I should start to see what?s going on?

Before

http://www.youtube.com/watch?v=3JrhP50qUMc





After
http://www.youtube.com/watch?


Reply With Quote


  #2  
Old 10-05-2018, 08:06 PM
Wypipo Wypipo is offline
Senior Member
 
Join Date: Sep 2018
Posts: 131
Default

One thing I noticed on the cable choke that I removed it has this hole in it. The plunger choke I installed was solid
Attached Images
File Type: jpg 9A506B83-7696-4CB4-A9ED-2D2AED060E41.jpg (86.3 KB, 20 views)
Reply With Quote
  #3  
Old 10-05-2018, 08:34 PM
Wypipo Wypipo is offline
Senior Member
 
Join Date: Sep 2018
Posts: 131
Default

Ok I put the original choke back in and same thing
Reply With Quote
  #4  
Old 10-05-2018, 08:46 PM
Jakobi's Avatar
Jakobi Jakobi is offline
Super Moderator
 
Join Date: Oct 2010
Location: Australia
Posts: 7,994
Default

Make sure the carb is seated in the manifold properly.

If it's not sealing between the carb and reed block it'll suck air and increase your idle. Same goes for other end of carb too, however the front manifold usually needs to be moved a bit to get the 14mm open ender on to change the choke assembly.
Reply With Quote
  #5  
Old 10-05-2018, 08:48 PM
gasgasman's Avatar
gasgasman gasgasman is offline
Super Moderator
 
Join Date: Jul 2006
Location: Pearland Texas
Posts: 4,594
Default

The hole is to lock the cable end in.

Check the free play on your throttle cable.
And all the intake hose clamps.
Reply With Quote
  #6  
Old 10-05-2018, 08:53 PM
Wypipo Wypipo is offline
Senior Member
 
Join Date: Sep 2018
Posts: 131
Default

I didn?t loosen the manifold, I just did the two hose clamps on either side and rotated the carb. I did tighten them back
Reply With Quote
  #7  
Old 10-06-2018, 07:51 AM
Wypipo Wypipo is offline
Senior Member
 
Join Date: Sep 2018
Posts: 131
Default

It was my throttle cable. Thanks for the help
Reply With Quote
  #8  
Old 10-06-2018, 09:38 AM
Wimpy525 Wimpy525 is offline
Senior Member
 
Join Date: Oct 2011
Location: Catawissa Pa
Posts: 394
Default

Need to watch the throttle cable on these bikes, one snag and its wide open. I always safety wire both ends to prevent it from pull out. I sure that Motion Pro has a replacement cable, just haven't looked yet.
Reply With Quote
  #9  
Old 10-06-2018, 10:00 AM
john r b's Avatar
john r b john r b is offline
Platinum Level Site Supporter
 
Join Date: Aug 2012
Location: Warrenton,Va
Posts: 956
Default

Motion Pro #10-3000 . This is a good cable, captive at both ends, however i have experienced water seeping into the top of the carb. I could never get a proper seal. Went back to stock.
__________________
'12 XC 200 TTX Sold
'15 XC 250E Sale pending
Reply With Quote
  #10  
Old 10-06-2018, 11:08 AM
RS1 RS1 is offline
Member
 
Join Date: Jan 2018
Posts: 12
Default

Quote:
Originally Posted by Wypipo View Post
It was my throttle cable. Thanks for the help
What was happening with your throttle cable?
Reply With Quote
Reply



Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
2018 - cable to plunger choke Gibnut Enduro Intake/Carburetion - 2 stroke 0 03-17-2018 12:20 AM
Help! I need a throttle cable for my 1999 EC300....fast! flatout111 Enduro Chassis & Body 5 08-25-2014 01:20 PM
Choke cable eliminator gasgasman Enduro Product Announcements 28 05-09-2011 09:43 PM
choke cable help???? nambo-trev Enduro Intake/Carburetion - 2 stroke 2 08-27-2010 09:23 AM
Cable choke for 03 250? marjastaja Enduro Intake/Carburetion - 2 stroke 3 02-28-2010 09:45 AM




All times are GMT -5. The time now is 04:36 AM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright 2009 - GasGasRider.org