|
Enduro Product Reviews Feedback & Comments on Products Tested |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
RB Designs carb work
On my '01 XC300, I wore the LTR needle and I wore the carburetor nozzle (where the needle slides in the carb). The LTR needle wore about 0.0005” over 3 years. During this time the engine became overly rich, especially in the 1/8-1/4 throttle range. Compensating with a leaner needle was partially successful.
Since RB Designs now replaces nozzles, I had Ron replace the nozzle. With the new nozzle, it works great. If you have a lot of hours on your GasGas and your engine runs overly rich at low throttle openings, I strongly recommend you have RB Designs replace your carb nozzle. Ron does top notch work!!
__________________
Eric K '06 GasGas EC300 '01 GasGas XC300 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
RB-Designs carb mod or PowerNow? | AZRickD | Enduro Intake/Carburetion - 2 stroke | 14 | 01-23-2009 05:50 PM |
RB Designs Carb Mod | Magellan | Enduro Product Reviews | 18 | 06-11-2008 01:44 PM |
Thanks to RB Designs & Gofasters | ejas | General Discussions & Announcements | 0 | 09-07-2007 05:10 AM |
RB Designs Carb Mod? | Boomhauer | Enduro Intake/Carburetion - 2 stroke | 4 | 03-20-2007 03:09 PM |
Welcome RB Designs... | webmaster | General Discussions & Announcements | 2 | 07-20-2006 08:37 AM |