|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#31
|
|||
|
|||
My bad on previous post. Choke has been checked and it does make a difference. It's just not a big one since it's running so rough already.
|
#32
|
||||
|
||||
That was the next step. Electrical. Spark plug, plug cable, coil, stator, cdi.
|
#33
|
||||
|
||||
Sounds like you might be on to something with the plug wire. Take the cap off and make sure you have a good connection. If you have the length you can cut them back and re-attach the cap. If you have a high resistance connection it's possible you're not firing good at certain rpms. Maybe that would explain all the spooge. I guess if you were burning tranny oil you'd know it by the smell.
I had a plug wire shot on a bike once and I recall the bike just breaking up when I started to get on the gas. Otherwise it idled fine, so a bit of a different scenario. There were only a few strands of wire left at the plug connection and I was able to cut it back to good wire and all was fine.
__________________
2011 Gas Gas EC300 38mm, 2008 Husky TE610, 2003 Beta Rev3 250 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
gas gas won't idle? read this! | ricardo cabeza | Enduro Intake/Carburetion - 2 stroke | 19 | 10-07-2013 01:33 PM |
Bad idle | Madhead | Enduro Intake/Carburetion - 2 stroke | 1 | 08-11-2011 06:20 AM |
Does not idle or rev | Binni | Enduro Intake/Carburetion - 2 stroke | 8 | 02-14-2011 03:29 PM |
can,t get idle up | geno | Enduro Intake/Carburetion - 2 stroke | 1 | 04-18-2010 08:49 PM |
EC 250 05 noo idle. settings?? | Laban1234 | Enduro Intake/Carburetion - 2 stroke | 5 | 07-21-2009 11:13 AM |