Longer throttle cable

[richgilb]

Local bike mechanic said he did not have the type required for my 2003 ec 200?

Whatever, anyone know where I can go to get one in UK maybe 6 inches longer than standard? I have stacked the front end with higher bars and used all the bar riser plates possible. I have rerouted the cable but it still pulls on tight turns.

[john r b]

motion pro # 10 3000 . i think it's plus 2 inches. best of luck.

[WAZ]

Venhill do cable kits. The carb end nipple is already fitted, so all you do is cut to length and solder the correct nipple for the throttle end. http://www.venhill.co.uk/Cables_-_Co...sal_Cable_Kits I've used them before and they are good quality. Check that the kit includes all you need, as I had to order a couple of extra small parts.

[richgilb]

Cheers guys. Bought a motion pro t3 throttle cable with an extra two inches

[(F5)]

Just as and add to for future ref.

On earlier twist top carb bikes the motion pro 10-3000 can work but here's my take. Just fitted one and to avoid a tight bend onto the under of tank to carb, I removed the carb end locknut and screwed it fully home. I also added some sealer goob and a cable tie on the rubber fitting as Jake suggested.

This makes the bend agreeable. But then there is too much free play so using a maap torch heated the nipple and moved it about 12mm down. Either side, I did throttle end. Then I melted some plumbing solder (not normal 60/40 electrical) into a puddle in a piece of metal, a spot of flux and plunged it in so it flowed all over then removed and held still for quite some time.

Dress end on a grinder carefully holding cable and jobs a goodun.

[john r b]

Good job F5, improvisation is the way to go.