|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
Sick of these Vforce 3 reeds!
I have a 2012 EC 300 Race model. I have 3 reed cages, 5 seperate complete sets of pedals. Every single set will not close a tight seal in the cages. I contacted Vforce directly about it. They sent me a cage already pre assembled. And guess what? The pedals are not closed/sealed tight! Hold it up to the light to only see gaps. People say they should ?close under vacuum?, but I don?t agree. Think of how one little chip will affect performance on any other machine.
So, sorry about the rant. Now, can anyone confirm if the older boyeson reed setup will fit and work in the 2012 model? |
#2
|
||||
|
||||
I would argue that it's really not a problem.
A reed valve is just a check valve. With a pressure differential in the one direction, the petals open. With a pressure differential in the opposite direction, the petals close. When your piston is rising in the cylinder, the pressure differential between the pressure in the cylinder and the atmosphere pushes the petals closed. The "small gap" keeps the reed off the cage when the pressure differential is insufficient to close the petals. The longer the petal doesn't contact the cage, the longer the petal is going to last (less movement between petal and the cage). Do you see any wear on the reed where it contacts the cage? if so, then it's sealing. I have a Boysen set on my 2002. I'd be happy to change for your V-force rig - the V-force is a much nicer piect. You'd be very unhappy with that trade. |
#3
|
||||
|
||||
Reeds never really close all the way.
The vacuum required to open the reeds is a lot less than the pressure required to close them. In other words, the reeds will seal just fine on the piston down stroke. |
#4
|
|||
|
|||
Can anyone confirm if the older model boyeson setup will fit the 2012 models?...
|
#5
|
|||
|
|||
is your bike running well with the new set you got sent?
indeed the petals will close once pressure is build up on the downstroke of the piston. don't worry, just go ride. |
#6
|
||||
|
||||
Does the bike run bad? If not, run it!
__________________
WildAzzRacing YouTube channel Trail Riders of Southern AZ club AZ State Parks OHV Ambassador '11 EC250R '98 KDX220 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
VForce 4 reeds | Wuzofoz | Enduro Intake/Carburetion - 2 stroke | 6 | 01-22-2020 07:11 PM |
Brand New VForce 3 replacement reeds | gasgasman | Parts | 0 | 12-25-2019 10:29 PM |
vforce 4 reeds on 2012 gasgas | chrille79 | Enduro Intake/Carburetion - 2 stroke | 4 | 10-17-2016 09:37 AM |
Vforce 3 reeds | candybuddy | Enduro Intake/Carburetion - 2 stroke | 1 | 08-03-2014 05:01 PM |
My motor is sick :( | Colemanian | Enduro Engine - 2 stroke | 9 | 06-02-2013 07:26 PM |