![]() |
|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
![]() |
|
Thread Tools | Display Modes |
#11
|
||||
|
||||
![]()
We did a mates last month. Only thing that got it fixed was a new needle.
I drop a ball bearing in the seat and tap it to ensure the hole is round. But do take your tap out and clean any tank grit. A hair will hold the valve open.
__________________
'07 EC300 496 CPI Cheetah RZ/RGV hybrid 675 Street Triple R RS125 framed MB100 racer Stinger T125 Suzuki |
#12
|
||||
|
||||
![]()
I have had good luck chucking up a cotton swab (Q-Tip), dipped in polishing compound (tooth paste in a pinch) into my electric drill. You can use this to polish the carb seat mating surface so the needle's Viton tip has a smooth surface to mate with or (with which to mate if you are opposed to ending sentences with prepositions) ;-)
https://www.quickanddirtytips.com/ed...-a-preposition Is it Friday yet? |
#13
|
||||
|
||||
![]()
Actually, it's Saturday morning
![]() |
#14
|
||||
|
||||
![]() Quote:
__________________
Back on a gassy! 2018 EC300! 🤘 |
#15
|
||||
|
||||
![]()
We replaced the seal/ball bearing tap after he'd tried this trick.
__________________
'07 EC300 496 CPI Cheetah RZ/RGV hybrid 675 Street Triple R RS125 framed MB100 racer Stinger T125 Suzuki |
![]() |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ohlins Forks 46mm Leaks Leaks and more Leaks | Zman | Enduro Suspension | 8 | 09-03-2017 08:42 AM |
Fuel dye | jerry623 | General Discussions & Announcements | 2 | 11-24-2014 09:34 PM |
no fuel efi | stockton | Enduro Engine 4 stroke (including EFI & Exhaust) | 1 | 08-08-2014 01:37 AM |
fuel & oil | knobbyboy | Enduro Engine - 2 stroke | 4 | 07-20-2014 06:37 PM |
Fuel range and fuel light | sanderjavant | Enduro Engine 4 stroke (including EFI & Exhaust) | 6 | 01-05-2008 03:35 AM |