|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Removing the fork cap?
I just bought a 2003 EC 250 and decided to change to fork oil, it has WP 43mm forks.
Any anybody have a short cut tool to hold the hydraulic stop to remove the cap? Mine takes a 22mm but the raised ends of the nut prevent it from sliding over the nut. Of course if I knew the oil capacity I could just drain and refill without completely removing the cap. I know setting the level is the proper method. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Removing '05 airbox cover | Trooper Sam | Enduro Chassis & Body | 7 | 01-23-2012 11:19 AM |
Suggestions on removing swingarm | roostafish | General Discussions & Announcements | 12 | 10-04-2009 10:11 PM |
Removing Rear Shock | gasIdaho | Enduro Suspension | 12 | 02-04-2009 10:45 AM |
Removing shock | thelonius | General Discussions & Announcements | 3 | 08-30-2007 08:50 PM |
Removing cartridges from 43mm WPs | SpeedyManiac | Enduro Suspension | 8 | 05-29-2007 06:33 AM |