Noob question re kill switch wiring

[rossrc]

Hi,

I've removed the OEM switch gear and connected a KDX kill switch. I did this by cutting the (hopefully) correct 2 wires behind the headlight unit and using a connector block to join them to the new kill switch.
Assuming I've got the right wires, my question is... Will this cause me any problems? Do I need to waterproof the connector block (I was thinking silicone with electrical tape around it) or should I use an alternative method to connect the wires (a mate suggested soldering and shrink wrap)?

Thanks in advance

Ross

[MattR]

What color wires did you cut?

Also, there are a couple of wiring diagrams located here for reference:
http://www.gasgasrider.org/html/manuals__etc.html

[rossrc]

yellow/black and black
I traced them from the original switch gear, so I'm fairly confident I've got that right... just worried that when I hit the first serious water that I'll run into problems

[gasmonkey]

What the^^^^^^^??? I want shoes,FAKE SHOES,not manbags.Bomber jackets will be next.

[coolum74]

Originally Posted by gasmonkey

What the^^^^^^^??? I want shoes,FAKE SHOES,not manbags.Bomber jackets will be next.

I'm confused

[MattR]

Yesterday, I deleted a spammer's post and also banned him. I forgot to delete gasmonkey's post since it no longer applies.

It sounds pretty funny though when you have nothing to reference it with.