|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2008 EC300 with no midrange power
I have a 2008 EC300 and it was running and jetted perfect. Then I had the ignition changed to the EC3 and a Trail Tech stator installed to run my HID lights and it runs like crap in the midrange. It feels like it is jetted wrong but re-jetting didn't change it much. The low end runs great but when you lay on the throttle it wont clear out. If you pull the clutch and get the RPM's up then it pulls like mad on the very top. Any suggestions on what it might be.
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1st ride 2008 ec300 | dgstandard | Ride Reports | 20 | 05-11-2010 08:07 PM |
Scary Fast Power Now on GG EC300 | Elvis74 | Enduro Intake/Carburetion - 2 stroke | 7 | 01-30-2010 08:52 AM |
IMS pegs on 2008 EC300 | lineman12345678 | Enduro Chassis & Body | 6 | 01-11-2009 03:24 PM |
07 ec300 - I need more power! | Hollywood | Enduro Engine - 2 stroke | 27 | 05-20-2008 02:27 PM |