|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2015 xc300e PV bearing
Anyone else have an issue with the little bearing at the power valve adjustment screw on a 2015 XC/EC ?? I've been through two of them now in 12hrs ! .... makes a horrible screeching noise.... first one was replaced @ the dealer under warranty and only lasted one ride ! .... seems they may be starving for oil as they're a shielded but not sealed bearing .... I may try to find an after market one with no shield (all open) and see what happens ...
|
#2
|
||||
|
||||
Lou what did you do with the bearing ? Did you get it fixed ?
__________________
IF I HAD ALL THE MONEY I SPENT ON DIRT BIKES , I WOULD SPEND IT ON DIRT BIKES |
#3
|
|||
|
|||
All is good
Yeah ..... all is good, I installed an open bearing with no shields/seals and it has been good for a while now. Not sure what type of bearing was originally in there as it completely came apart. I've been running it pretty hard and it's been a very solid machine .....absolutely no complaints whatsoever !!
|
#4
|
||||
|
||||
For future reference, the metal shields in shielded bearings are easily removed with a small pick or scriber.
(This is a general tip, not necessarily specific to PV's) Sent from my iPhone using Tapatalk |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2015 XC300e | lou1265 | Pictures & Videos | 8 | 06-03-2015 05:25 PM |
2013 Gas Gas XC300E - Oklahoma City | phoenix | Used Bikes | 0 | 05-16-2015 10:12 AM |
2014 XC300E limp shifter | mtnmanseth | Enduro Engine - 2 stroke | 1 | 03-24-2015 05:47 PM |