|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Zoke 48 bleed screw thread
I asked this before in another thread but no reply. Is it 4 or 5mm? Thanks.
|
#2
|
|||
|
|||
My answer just recently today from motion pro is 4mm x .7, readily available for shipment
now that I have a clue, I will dig out my metric tap set and verify before ordering, all over the USA for 15-20$ shipped to the door, multiple vendors. Last edited by Mazikeen; 04-25-2012 at 01:45 PM. Reason: will verify |
#3
|
||||
|
||||
Thanks. I have a new 5mm set laying around for years, maybe I'll just drill & tap for 5mm if there is enough material. A little stronger than the 4mm parts too.
|
#4
|
|||
|
|||
Its the same as the late model KTM. Don't get the Moose ones as they won't fit in the hole.
|
#5
|
||||
|
||||
If the Motion Pro 4mm for KTM, for the adj preload fork caps or standard fork caps?
|
#6
|
|||
|
|||
I am waiting for the return answer to that question, they first answered only they were 4mm x .7, I went to order some, found two versions with no specification difference i can find. I will post the response as soon as i get it.
|
#7
|
||||
|
||||
what's the size on the shiver - same?
__________________
07 ec300 was 00 xc200 now a 00 xc300. now parting out. 99 ec300 (now a pile of parts which are for sale) Stainless Cycle - Motorcycle Bolt Kits www.stainlesscycle.com |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
please help....can't bleed clutch | Zhack | Enduro Engine - 2 stroke | 2 | 10-12-2011 12:09 PM |
how to bleed clutch | austin.s24 | Enduro Engine - 2 stroke | 4 | 09-17-2011 11:14 AM |
clutch bleed screw | Oldcow | General Discussions & Announcements | 2 | 07-19-2008 06:01 AM |
Base valve free bleed, what does it do? | bergerhag | Enduro Suspension | 2 | 06-11-2008 08:04 PM |
How do I bleed my clutch? | lukachuki | Enduro Engine - 2 stroke | 3 | 09-24-2007 02:53 PM |