|
Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
Thread Tools | Display Modes |
#71
|
||||
|
||||
Yes, yes and yes. PM sent.
|
#72
|
||||
|
||||
The sump guard is a 6mm AXP unit with link guard. Additional graphics are from the UK GasGas importer's accessory site via the link in my earlier post.
Enduro Engineering wraparound guards and rim decals from eBay in the UK. The UK GasGas importer, John Shirt, is a really good guy, veteran expert rider and has been the importer since GasGas started in the UK. He has massive spares stocks going back to early models and ships worldwide every day. |
#73
|
|||
|
|||
Great thread--subscribed, as I've got a 2014 Christini with what appears to be a 2013 (at the newest) GASGAS 300 EC in it. Per the GG shop manuals, the bike should have a Keihin 38 on it, but I've only recently got the bike and haven't yet got good access to it where it's stored.
Did the carburetion change significantly from 2013 to 2019 on GG's 300 EC's? Thanks. |
#74
|
|||
|
|||
EC300 2019 jetting
Hi all, been reading all the posts re, jetting for 2019 EC300. I?ve just picked up a low mileage 18hrs only EC300 and it?s running a bit rich. I live on the Gold Coast Australia and ride from 0-500 feet in temps of 13-30?c. Previous owner mentioned jetting is pretty standard, I think he changed the main but not the pilot or needle. Running Maxima Castor at 40-1, this was already in the bike and I had planned to use the same, I?m a bit old school!. I now many of you mention to change the needle and main, but so many posts I?m getting a bit lost. Any guidance on base settings would be much appreciated. Thanks
Quote:
|
#75
|
|||
|
|||
I always used 40:1 but the reality is that you jet according to your mix.
so stick with one mix and adjust the jetting (I would also go a bit further and stick with one 2-stroke oil too)
__________________
2003 txt250 Pro 2013 Ossa 280i |
#76
|
|||
|
|||
Im in Sydney have a 2021 reiju ,which is same as yours I ride in same temps and elevations . NEDW needle on 2nd clip from top ,40 pilot ,air screw 1 1/2 turns out ,standard main .The needle is a triple taper as opposed to the double taper standard needle. Its from a Suzuki RM 250 . MX store on the Gold Coast will have it .Good luck
|
#77
|
|||
|
|||
And try 50:1
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2019 Gas Gas updates | swazi_matt | General Discussions & Announcements | 150 | 10-29-2018 05:24 PM |
2019 EC 300 first ride (euro model) | Doc Brown | Ride Reports | 7 | 09-19-2018 01:17 PM |
2019 gp | CORSA | General Discussions & Announcements | 1 | 08-02-2018 06:37 AM |
Poll 2019 KTM XCW 300 TPI 6 Days | Moto7man | Pictures & Videos | 16 | 06-28-2018 03:43 PM |
2019 KTM XCW 300 TPI 6 Days | Moto7man | Pictures & Videos | 2 | 06-21-2018 03:20 PM |