|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Torque Spec's Triple Clamp Pinch Bolts?
04 DE 200 with 45mm Zokes, what is the recommended torque for the top and bottom triple clamp pinch bolts?
The info I found list the Triple Clamp bolts 29 N-m / 21 FT LBs / 256 IN Lbs Is this correct? |
#2
|
|||
|
|||
Right here: http://www.gasgasrider.org/torque_table.jpg
That may be for WP but should be good for 'zokes too. |
#3
|
||||
|
||||
Thanks a bunch
|
#4
|
|||
|
|||
You try 21 ft-pounds on a pinch bolt and you'll snap it.
|
#5
|
|||
|
|||
16Nm with 1/4" drive torque wrench as per the table in the technical section, no problems yet.
|
#6
|
||||
|
||||
Quote:
WP forks: Triple clamp upper bolt = 20 N-m / 15 Ft-lb Triple clamp lower bolt = 16 N-m / 12 Ft-lb Marzocchi forks: Triple clamp upper bolt = 20 N-m / 15 Ft-lb Triple clamp lower bolt = 12 N-m / 9 Ft-lb
__________________
Matt Current: 2009 Yamaha FZ1 Previous: 2001 GasGas TXT280, 2001 GasGas XC250, 2004 KTM 200EXC, 2007 GasGas EC250, 2007 Husqvarna SM610, 2008 Husqvarna WB165 |
#7
|
||||
|
||||
Either fork doesn't need much. Les told me he has seen forks with the internal anodizing worn completely away in the lower clamp area from over tightening. I run mine around 10 -12Nm but may even go lower as long as they don't slip. Also consider that if you antiseize the bolts like you should, this can increase the overall torgue by as much as 30% for the same wrench setting.
GGs aren't that bad, if you ever work on a new Husky you wonder if they ever calibrate the wrenches at the factory, some of the bolts are crazy tight. FWIW, a friend of mine in town went out riding after working on his KTM the night before. He said for some reason the forks worked great, he felt like a hero. To his surprise he discovered that he had never torqued the lower clamp, it was just snugged up! |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Triple clamp ?? | rippn450 | Enduro Suspension | 22 | 04-18-2011 09:21 PM |
Front axle bolts Torque setting | biggstr6 | General Discussions & Announcements | 6 | 04-23-2010 08:01 AM |
Top triple clamp | pharrell | Enduro Chassis & Body | 10 | 01-16-2009 12:57 AM |
BRP top triple clamp | Link | General Discussions & Announcements | 1 | 11-08-2007 08:28 AM |