![]() |
|
Enduro Suspension Tuning & maintenance of Enduro forks, shocks, etc |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
I am about to change the fork springs on a '13 EC300 with the twin chamber Marzocchi's.
From what I can tell the oil level on the outer tubes is 330cc's. Can anyone confirm this? I am guessing 5w oil? *Edit - I found this PDF manual on the Marz site: http://moto.marzocchi.com/en/front-f...12002&LN=en-US It states 320cc @ 7.5w. A confirmation on this would be awesome, thanks. |
#2
|
|||
|
|||
![]()
I used 320cc w 7.5 and it seems to work well. Side note when I drained my old original oil each leg only produced around 200cc.
Sent from my iPhone using Tapatalk |
#3
|
|||
|
|||
![]()
I am seeing the same thing, very little oil in each leg.
|
#4
|
||||
|
||||
![]()
Its not uncommon for these forks to do something with the oil. Its been mentioned by many people that over time the level drops. I think its a combination of some being cycled through the cartridge and then sitting above the ICS piston, some being in the chamber (overfilled waiting to be purged), some being between the inner/out fork legs, and some being used to lubricate the lower fork.
All these little bits must add up. I found them to have high service intervals, and its in your best interest to try and follow them. |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Oil level on 43mm fork | Thomas R | Enduro Suspension | 14 | 08-02-2014 10:15 AM |
50mm Marzochi fork oil level | PEB | Enduro Suspension | 0 | 03-09-2014 05:24 PM |
Fork oil level in 45 zokes 2011 300 ? | ryangroch | Enduro Suspension | 8 | 10-13-2012 10:30 PM |
Fork oil level ? | Brian VT | Enduro Suspension | 4 | 03-10-2009 08:57 PM |
WP Fork Oil Level | MattR | Enduro Suspension | 11 | 08-02-2006 10:40 AM |