|
|
|||||||
| Enduro Engine - 2 stroke Cylinder, Piston, Tranny, Bearings, Clutch, Pipes & Silencers, etc. |
|
|
Thread Tools | Display Modes |
|
#1
05-13-2011, 12:27 PM
|
||||
|
||||
Tricks for holding down head o-rings?
I've got my top end back together and my o-rings don't seem to want to lay down nicely in the grooves. They pop right out as if they are a wee bit small in diameter. These are 10 years old. I got them from Jim when I bought the bike, and unwisely waited a decade to pull the jug. So, maybe they shrank a bit. I dunno...
 I'm thinking of a drop of candle wax here and there to hold them down.  Edit: 2001 xc300 Last edited by motogroove; 05-13-2011 at 12:28 PM. Reason: FYI 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Head O rings | Highwayman | Enduro Engine - 2 stroke | 8 | 02-04-2010 08:43 PM |
| Actual size of cyl. Head o-rings? | barbwire44 | Enduro Engine - 2 stroke | 4 | 10-11-2009 01:29 AM |
| Cyl/Head o-rings why so small | Treesmacker | Enduro Engine - 2 stroke | 9 | 02-19-2009 11:09 PM |
| carb tricks again .... | skid jackson | Enduro Intake/Carburetion - 2 stroke | 6 | 07-25-2008 01:33 AM |
| Cylinder head o-rings crossover ??? | Marcão | Enduro Engine - 2 stroke | 5 | 09-13-2006 08:33 PM |
Threaded Mode