|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Dripping gas and WOT gurgle
I'll say up front I don't think these 2 issues are related. Perhaps I'm wrong.
My bike has started dripping gas when it's sitting on the stand. From my reading on this forum it sounds like I need to check the float height and also the seal on the float needle. Does that sound right? She also has a pretty good gurgle at WOT. Do I need to look at my main jet to try to clear that up? My dealer put a JD Jetting Kit in it for sealevel as I live in central Texas. Other than that I'm not sure what main jet is in it.
__________________
Slade '14 GG XC300R - County Cycle Woods Weapon #63 |
#2
|
|||
|
|||
I had a drip of fuel on my carb,one of the phillips head screws @ the bowl was alittle striped out,not allowing screw to tighten enough,switched them out to allen head bolts now.Dont know about the wot issue.
|
#3
|
||||
|
||||
I'd do the float first, and ride to see if you got 2 birds with one stone.
__________________
All healed up, and ready to burn some fat. |
#4
|
|||
|
|||
If there was no leakings in past I would not touch the level.
Rather I would change the needle valve. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
03 EC/DE Power Valve service - dripping goo! | pbspecial | Enduro Engine - 2 stroke | 4 | 12-12-2006 05:22 AM |