|
|
|||||||
| Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
|
Thread Tools | Display Modes |
|
#1
02-28-2007, 03:14 PM
|
||||
|
||||
Clip position ?
I ride a 2002 250 EC
Can anyone tell me what the clip position actually does, The manual recommends my set up in the central position. What effect does putting the clip higher or lower have ? My settings are Needle N1ef main jet 178 Pilot 38 slide 6 altitude 300 ft above sea level Does this set up look ok if not what changes would you make ? Thanks
__________________
Matty 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Handlebar mounting position | bchatt | Enduro Chassis & Body | 8 | 10-14-2010 05:34 AM |
| neddle position Question | biggstr6 | Enduro Intake/Carburetion - 2 stroke | 8 | 05-12-2010 10:26 AM |
| Euro Enduro Clip | Rick | Pictures & Videos | 1 | 12-09-2008 05:55 AM |
| Throttle position sensor adjustment? | bergerhag | Enduro Engine 4 stroke (including EFI & Exhaust) | 3 | 05-08-2008 06:46 AM |
| helmet cam clip | fury1 | Pictures & Videos | 2 | 11-20-2007 04:42 PM |
Threaded Mode