|
|
|||||||
| Enduro Engine 4 stroke (including EFI & Exhaust) 4 stroke engine, EFI, and exhaust discussion |
 |
|
|
Thread Tools | Display Modes |
|
#1
05-07-2008, 02:45 PM
|
||||
|
||||
Throttle position sensor adjustment?
According to the VSDST software from technoresearc, my tps only registers 59.7 degrees at WOT, 4.1 degrees at closed(idle).
Is this adjustable or is my tps bad and need replacement? 
|
|
#4
05-08-2008, 06:46 AM
|
||||
|
||||
|
I used a cheap multi-meter and measured resistance. The tps is setup to deliver a voltage to the ecu, the potentiometer is supplied +5v and gnd, and center output is the metering circuit.
The resistance between gnd and output is 1.35 kOhms at idle, and 2.15 kOhms at wot
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Handlebar mounting position | bchatt | Enduro Chassis & Body | 8 | 10-14-2010 05:34 AM |
| neddle position Question | biggstr6 | Enduro Intake/Carburetion - 2 stroke | 8 | 05-12-2010 10:26 AM |
| oil sensor 450fse 03 | jjbaker1 | Enduro Engine 4 stroke (including EFI & Exhaust) | 1 | 03-12-2009 05:54 AM |
| Odo sensor on B/O | TooBadBrad | General Discussions & Announcements | 2 | 06-21-2007 07:23 PM |
| Clip position ? | thingymijig | Enduro Intake/Carburetion - 2 stroke | 3 | 03-01-2007 04:57 AM |
Linear Mode
