|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2010 EC250 AS2 base settings
Hi all,
After having bought a bit of a lemon - It turns out the rads were near empty, blew a head gasket, white smoke, jug off and saw scores, so thats off being plated, new rads, new piston kit...! So, while that's being sorted im giving the bike a full once over! Full swingarm/rocker bearings are being done and im now onto checking the reeds/carb. It has the standard N1EF needle (2nd clip), so i have bought a NEDW to replace it with (planning 2nd clip again?). It has a 178 main and a 42 pilot and the air screw was 1 turn out when i got it. Im based in the UK, so low altitude and its going into winter so temps are 0-20 degrees celcius. Can anyone suggest if this is a good starting point for me? Should i drop to a 40 maybe? (i ride mainly green lanes, single track natural stuff, some enduro. Not really a MX track kind of guy) Suggestions very welcome. Last edited by touringhornet; 11-16-2017 at 05:34 AM. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2010 ec450 throttle position sensor settings? | Finnyfire | Enduro Engine 4 stroke (including EFI & Exhaust) | 6 | 07-27-2017 04:33 PM |
2011 suspension Base settings | Quigs | Enduro Suspension | 1 | 11-29-2016 03:23 PM |
2010 Sach stock suspension settings? | 007neil | Enduro Suspension | 4 | 06-20-2012 02:14 PM |
2010 Nambo TTX settings | spiderpig | Enduro Suspension | 2 | 08-11-2011 07:02 AM |
2010 300 Cylinder Base Gasket Question | coopernicus | Enduro Engine - 2 stroke | 12 | 06-22-2011 09:31 PM |