Red anodised parts????? Where to find..

[GASGAS450]

Hi all, mobs like RHK, APICO and others do these coloured anodised "bling kits" for all the jap stuff, KatM, and Husky.

Anyoneknow of any anodised red bolt on bits?

Like the pic attached. My master cyl covers, etc are scratched up, might aswell bling it a little ah???

[Gas Gassin]

The only place I have seen any anodized anything is V-mar racing and it's just the reservoir caps I got one for the clutch master cylinder.
Also there's this place below. I've never got anything from them just saw it in my search for anything GasGas. go to the top left hand corner it has a USD for the exchange rate. Not sure if they ship to the States.

http://www.enduropuro.it/shop/en/83-engine

[WAZ]

You do realise that red anodising fades to pink don't you? This may not be a problem to you, but should be considered.

[Fred1956]

Check with S3 products

[elemetal2]

If the anodizing is done as per exterior, class II it will not fade. Only if done with a dye finish rather than a 2 step dye finish, then it will fade.

[Gas Gassin]

Wish it came in pink I'd buy it cause no one else would. I love THE PINK.

Also got a response from Enduroquro they say they can ship to the States. Cost 30 to 40 Euro for shipping thats like $44. They use DHL

[gasgasman]

Lookey here....

http://www.gasgasrider.org/forum/sho...highlight=geco