|
Enduro Intake/Carburetion - 2 stroke Jetting, Reeds, Air Filters, etc. |
|
Thread Tools | Display Modes |
#1
|
||||
|
||||
Sheridan mtn
Wondering if anyone could pass me some baseline jetting for the Sheridan mtn, AZ area. I have the chance to ride out there this weekend but I'm jetted for around 600 ft. Right now I have the NEDJ, 175 main, and 42 pilot. I don't have any other jets with me but will pick some up.
Bike is an 09 300 |
#2
|
|||
|
|||
How thick is that needle ?
With an RB modded carb, I would usually do 172/42 (edge of rich) unless it got warmer than typical April temps. |
#3
|
||||
|
||||
I do not know the diameter. It is an asII 38mm BTW. My current jetting is nice in cave creek, but probably won't be up higher?
Temps in the low seventies probably |
#4
|
|||
|
|||
If you like what you have, then try 172/40 at Camp Wood/Sheridan Mtn.
Expect 2k to 3k elevation changes dependin on how deep into the southern valley you go, so don't go toooo lean. |
#5
|
||||
|
||||
I just put in 172/40. I'll leave my nedj on the second clip for starters, or should I go middle to start. Thanks for the tips. I picked up a few different pilots from screwy Louis.
|
#6
|
|||
|
|||
Your 40P should be good up there. I took a second look and found I had 175M, but the only time I was on the main jet was on the transfer roads between tests.
|
|
|